Robustel R3000 User Guide - Manual (Page 42)

Robustel GoRugged R3000 User Guide
RT_UG_R3000_v.2.0.0 17.01.2014 41 / 131
Confidential
IP Address, Netmask,
MTU, Media Type @ LAN
Interface
Set the IP address, Netmask, MTU and Media Type of Eth1. These
parameters will be un-configurable if you enable Bridge.
Null
Multiple IP Address @
LAN Interface
Assign multiple IP addresses for Eth1. Null
Enable DHCP Server @
DHCP Server Enable to make router can lease IP address to DHCP clients which
connect to Eth1.
Enable
IP Pool Start, IP Pool End
@ DHCP Server Define the beginning (IP Pool Start) and end (IP Pool End) of the pool of
IP addresses which will lease to DHCP clients.
192.168.0.2/
192.168.0.10
0
Netmask @ DHCP Server
Define the Netmask which the DHCP clients will obtain from DHCP
server. 255.255.255.
0
Lease Time @ DHCP
Server(min) Define the time which the client can use the IP address which obtained
from DHCP server.
60
Primary/Secondary
DNS Server @ DHCP
Server
Define the primary/secondary DNS Server which the DHCP clients will
obtain from DHCP server. 192.168.0.1/
0.0.0.0
Windows Name Server @
DHCP Server Define the WINS Server which the DHCP clients will obtain from DHCP
server.
192.168.0.1
Static Lease @ DHCP
Server Define to lease static IP Addresses, which conform to MAC Address of
the connected equipment.
Null
Router can be DHCP Relay, which will provide a relay tunnel to solve problem that DHCP Client and DHCP Server is
not in a same subnet. This section allow user to configure DHCP Relay settings.
DHCP Relay @ Ethernet
Item Description Default
Enable Eth0/1
VLAN@Eth0/1 VLAN
Settings
Enable to make router can encapsulate and de-encapsulate the VLAN
tag.
Disable
VLAN ID@Eth0/1 VLAN
Settings
Set the Tag ID of VLAN 10/11
IP Address, NetMask
@Eth0/1 VLAN Settings
Set the IP address, Netmask of VLAN interface
Eth0/1’s IP
address,
Netmask
Note: IP Address and NetMask will be hidden if user bridge two Ethernet ports.