Robustel R3000 User Guide - Manual (Page 129)

Robustel GoRugged R3000 User Guide
RT_UG_R3000_v.2.0.0 17.01.2014 128 / 131
Confidential
Building configuration...
OK
R3000#reload
!Reboot the system?'yes'or 'no':yes //reload to take effect
Example 3: Set link-management
R3000> enable
Password: *****
R3000#
R3000# configure
R3000(config)# set link-management
wan link :
1.Cellular Only
2.Eth0 Only
3.Eth0 as primary and if fail use Cellular
4.Cellular as primary and if fail user Eth0
->please select mode(1-4)*1+:2 //select “Eth0 Only” as wan-link
->ICMP detection primary server[]:8.8.8.8
->ICMP detection second server[]:8.8.8.4
->ICMP detection interval(3-1800)[30]:
->ICMP detection timeout(1-10)[3]:
->ICMP detection retries(1-20)[3]:
->reset the interface?'yes'or'no'[no]:
this parameter will be take effect when reboot!
really want to modify[yes]:
R3000# write //save current configuration
Building configuration...
OK
R3000# reload
!Reboot the system ?'yes'or 'no':yes //reload to take effect
Example 4: Set IP address, Gateway and DNS for Eth0
R3000> enable
Password: *****
R3000#
R3000# show link-management //show current link-management
*********************************************
wan link : Eth0 Only // now “Eth0 Only” as wan-link
ICMP primary server : 8.8.8.8
ICMP second server : 8.8.8.4