RKI Instruments GX-2009 Data Logger Management Program - Manual (Page 5)

Introduction • 5
Introduction
NOTE: The bump test function in Calibration Mode is included
in instruments with firmware version 03955 or later
installed. See the GX-2009 Operator’s Manual for a
description of the bump test function. GX-2009
instruments shipped after May 2011 include the bump
test function. Instruments that have a serial number
starting with 04516 or later shipped from the factory with
the bump test function available. Instruments that have
a serial number starting with 04515 did not include the
bump test function when shipped from the factory. The
factory setting for the bump test function is off.
Using an advanced detection system consisting of up to four gas
sensors, the GX-2009 Personal Gas Monitor detects the
presence of combustible gases, oxygen (O
2
), carbon monoxide
(CO), and hydrogen sulfide (H
2
S) simultaneously. The
GX-2009’s compact size and easy-to-use design make it ideally
suited for a wide range of applications as described in the GX-
2009 Operator’s Manual. Please read the GX-2009 Operator’s
Manual first before using the GX-2009 Data Logger
Management Program.
The GX-2009 Data Logger Management Program downloads
stored data in the GX-2009 to a Windows-based PC. After the
data has been downloaded, you can view, save, or print it using
your computer and the GX-2009 Data Logger Management
Program.
The purpose of this manual is to explain how to use and set up
the GX-2009 Data Logger Management Program. You will learn
how to:
• install and launch the software
• install the downloading cable (if needed)
• access and store data in a common database
• download data from the GX-2009