MacDon FD70 for Combine Operators - Manual (Page 67)

SECTION 8.1 D50, D60 HEADER AND ADAPTER
Form 169006
65
Revision D
k. If quick disconnects are installed, disconnect as
follows:
1. Line up slot (M) in collar with pin (N) on
connector.
2. Push collar toward pin, and pull connector to
disengage.
3. Install plugs or caps on hose ends
(if equipped).
l. Disconnect electrical connector by turning collar
counter clockwise, and pulling connector to
disengage.
m. Store and secure hoses on adapter.
n. Disconnect reel hydraulics at right side of
adapter. Install caps and plugs on fittings.
o. If multi-coupler is installed, disconnect as follows:
1. Push in lock button (O), and pul
l
handle (P) to
release coupler (Q).
2. Push handle down until button (O) snaps out.
3. Store hoses over adapter frame.
p. Ensure header is on ground, or is supported by
wheels in transport mode or jack stand.
q. Slowly back combine away from header.
r. Re-insert pins (R) in legs of header.
N
M
O
P
Q
R