MacDon FD70 for Combine Operators - Manual (Page 111)

SECTION 9. OPERATION
Form 169006
109
Revision D
D50
a. Open endshield.
b. Remove from storage.
c. Position crop divider as shown by locating lugs
(B) in holes in endsheet.
d. Lift forward end of divider, and install bolt (A),
lock-washer, and flat washer. Tighten bolt.
e. Check that divider does not move laterally.
Adjust bolts (C) as required to tighten divider and
remove lateral play when pulling at divider tip.
f. Close endshield.
9.11.12.5 Rice Dividers
Optional special rice dividers can be installed and
used when required. See Section 12.15 RICE
DIVIDER KIT.
The installation and removal procedures are the
same as for the standard crop dividers.
B
A
C