MacDon FD70 for Combine Operators - Manual (Page 131)

SECTION 10. MAINTENANCE AND SERVICING
Form 169006
129
Revision D
10.3 MAINTENANCE SPECIFICATIONS
10.3.1 Recommended Torques
 Tighten all bolts to the torques specified in
chart (unless otherwise noted throughout this
manual).
 Check tightness of bolts periodically, using
bolt torque chart as a guide.
 Replace hardware with the same strength
bolt.
 Torque figures are valid for non-greased or
non-oiled threads and heads (unless
otherwise specified).
 Do
not grease or oil bolts or capscrews
unless specified in this manual.
 When using locking elements, increase
torque values by 5%.
10.3.1.1 SAE Bolts
BOLT
DIA. "A"
in.
NC BOLT TORQUE*
SAE-5 SAE-8
lbf·ft N·m lbf·ft N·m
1/4 9 12 11 15
5/16 18 24 25 34
3/8 32 43 41 56
7/16 50 68 70 95
1/2 75 102 105 142
9/16 110 149 149 202
5/8 150 203 200 271
3/4 265 359 365 495
7/8 420 569 600 813
1 640 867 890 1205
* Torque categories for bolts and capscrews are identified
by their head markings.
10.3.1.2 Metric Bolts
BOLT
DIA.
"A"
STD COARSE BOLT TORQUE*
8.8 10.9
lbf·ft N·m lbf·ft N·m
M3 0.4 0.5 1.3 1.8
M4 2.2 3 3.3 4.5
M5 4 6 7 9
M6 7 10 11 15
M8 18 25 26 35
M10 37 50 52 70
M12 66 90 92 125
M14 103 140 148 200
M16 166 225 229 310
M20 321 435 450 610
M24 553 750 774 1050
M30 1103 1495 1550 2100
M36 1917 2600 2710 3675
* Torque categories for bolts and capscrews are identified
by their head markings.
SAE-5 SAE-8