MacDon FD70 for Combine Operators - Manual (Page 110)

SECTION 9. OPERATION
Form 169006
108
Revision D
D50
a. Raise header, and engage lift cylinder lockouts.
Refer to combine operating manual.
b. Open header endshield. Refer to Section 10.4
ENDSHIELDS AND COVERS.
c. Remove bolt (A), lock-washer, flat washer, and
lower divider (B).
d. Lift divider off endsheet.
e. Close header endshield.
9.11.12.4 Installation
D60, FD70
a. Open header endshield.
b. At divider storage location, lift divider to
disengage lugs (D) at lower end, and then lower it
slightly to disengage pin (E) from endsheet.
c. Position crop divider as shown by locating lugs
(D) in holes in endsheet.
d. Lift forward end of divider until pin (E) at top of
divider engages and closes latch (F).
e. Push safety lever (G) down to lock pin in latch.
f. Check that divider does not move laterally.
Adjust bolts (H) as required to tighten divider and
remove lateral play when pulling at divider tip.
g. Close endshield.
(continued next page)
B
A
E
D
D
E
H
G
F