MacDon FD70 for Combine Operators - Manual (Page 58)

SECTION 7.7 NEW HOLLAND CR, CX
Form 169006
56
Revision D
7.7.2 Detachment
a. Choose a level area. Position header slightly off
the ground. Stop engine, and remove key.
DANGER
To avoid bodily injury or death from fall of
raised machine, always engage lift cylinder
stops before going under header for any
reason. See your Combine Operator’s Manual
for instructions for use and storage of header
lift cylinder stops.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
b. Engage the adapter float locks by lifting lever (A)
at each lock until it latches into the “lock position”.
IMPORTANT
If slow speed transport wheels are
installed, header may be detached in
either Transport or Field mode.
If detaching with wheel in Field mode,
set wheels to storage or “uppermost
working position”. Otherwise header
may tilt forward so that re-attachment
will be difficult. Refer to Section 9.11.2
Cutting Height.
IMPORTANT
If stabilizer wheels are installed, set
wheels to storage or “uppermost
working position”. Otherwise header
may tilt forward so that re-attachment
will be difficult. Refer to Section 9.11.2
Cutting Height.
c. Disconnect driveshaft (B) from combine, and slide
driveshaft in hook (C) so that disc (D) drops to
secure driveshaft.
d. Remove hydraulic quick coupler (E) from
receptacle on adapter as follows:
1. Push in lock button (F), and pull handle (G) to
release coupler (E).
2. Push handle (G) to closed position until lock
button (F) snaps out. Close cover.
(continued next page)
E
F
G
K
C
D
B
A
UNLOCK
LOCK