MacDon FD70 for Combine Operators - Manual (Page 140)

SECTION 10. MAINTENANCE AND SERVICING
Form 169006
138
Revision D
e. To achieve a snug fit between aft end of shield
and header frame, loosen bolts (F), and adjust
latch (G) to re-position shield.
f. Tighten bolts (F).
10.4.2 Linkage Cover (FD70
FLEXDRAPER ONLY)
a. To remove balance linkage covers (A), remove
screw (B), and lift outboard end of cover.
b. Rotate upward until inboard end can be lifted off.
c. To install the cover, locate inboard end over
linkage and behind indicator bar (C).
d. Lower cover until secure and against the header
tube.
e. Install screw (B).
B
A
C
F
G