MacDon FD70 for Combine Operators - Manual (Page 38)

SECTION 7.3 CASE IH 2300, 2500 SERIES
Form 169006
36
Revision D
7. Connect hose (Q) from combine to adapter
coupler (S).
8. Connect hose (R) from the adapter to the
combine coupler (T).
d. Connect adapter electrical harness (U) to
combine electrical connector, and if applicable
connect AHHC wire harness at U1.
e. Open guard (V) at combine output shaft.
f. Rotate disc (W) on adapter driveline storage
hook, and remove driveline from hook.
g. Pull back collar on end of driveline, and push onto
combine output shaft (X) until collar locks. Close
guard (V).
h. If adapter is equipped with reel fore-aft/header tilt
selector, connect harness (Y) to combine.
i. Disengage both adapter float locks by moving
latch (Z) away from adapter, and moving lever (A)
at each lock to “lowest position”.
Q
R
S
T
U1
U
X
V
Y
A
LOCK
UNLOCK
Z
W