MacDon FD70 for Combine Operators - Manual (Page 138)

SECTION 10. MAINTENANCE AND SERVICING
Form 169006
136
Revision D
d. Adjust the endshield to achieve the gap ‘X’
between the front end of shield and header frame
in accordance with the following chart.
TEMPERATURE
Degrees ˚F (˚C)
GAP ‘X’
Inches (mm)
25 (-4) 1.1 (28)
45 (7) 1.0 (24)
65 (18) 0.79 (20)
85 (29) 0.64 (16)
105 (41) 0.5 (12)
125 (52) 0.32 (8)
145 (63) 0.16 (4)
165 (89) 0
e. Tighten bolts (D) and (E).
f. To achieve a snug fit between the aft end of the
shield and header frame, loosen bolts (G), and
adjust the latch (H) to re-position the shield
(shown in previous column).
g. Loosen bolts (J) on endshield support, and adjust
endshield to align with endsheet as shown above.
h. Tighten bolts (G) and (J).
i. Close endshield.
10.4.1.1.2 Removal
a. Open endshield.
b. Remove screw (K) at top of support tube.
c. Lift endshield off support tube.
X
J
K
G
H