MacDon FD70 for Combine Operators - Manual (Page 32)

SECTION 7.2 CASE IH 7010, 8010, 7120, 8120, 88 SERIES
Form 169006
30
Revision D
7.2 CASE IH 7010, 8010, 7120, 8120,
5088, 6088, 7088
7.2.1 Attachment
IMPORTANT
Some combine models require special
center-link components to ensure
clearance to the combine cab.
To avoid damage to your combine, lift
feeder slowly and check clearance
between cab and header center-link.
If clearance is inadequate, contact your
MacDon Dealer to order special center-
link components. Refer to Section 7.1.1
Center-Link Kit.
a. Slowly drive combine up to adapter until feeder
house saddle (A) is directly under the adapter top
cross member (B).
b. Raise feeder house slightly to lift adapter,
ensuring feeder saddle is properly engaged in
adapter frame.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
c. Lift lever (C) on adapter at left side of feeder
house, and push handle (D) on combine to
engage locks (E) on both sides of the feeder
house.
d. Push down on lever (C) so that slot in lever
engages handle to lock handle in place.
e. If lock (E) does not fully engage pin on adapter
when (C) and (D) are engaged, loosen bolts (F),
and adjust lock as required. Re-tighten bolts.
f. Connect combine hydraulic quick coupler to
receptacle (G) on adapter as follows:
1. Open cover (H).
2. Push in lock button (J), and pull handle (K) to
“full open” position.
(continued next page)
D
C
E
F
K
H
J
G
N
A
B