MacDon 871 Combine Adapter - Manual (Page 59)

59
Adapter Mounting Instructions
for Cat Lexion Combines
PREPARING THE HEADER
1. Prior to assembly of reel, install auto
reel speed and height sensors using
instructions packaged with kit. See
page 64 for harness connection at
multi-link. Route harness (A) from auto
speed & height sensors as shown on
instructions.
2. Clamp control box (F) to header tube
using the ½ x 4 inch bolt at both sides
of box. Position box 280 mm (11
inches) away from left header lift leg as
shown.
3. Route header reel lift hose (G) through
opening at top of control box and
connect to reel lift fitting (B). Coil
excess hose inside control box cover.
962 Header only: Attach reel lift hose
(from header completion package) at
left of delivery opening as follows:
For 30' headers the reel lift hose
connects to hydraulic line (D).
For 36' headers the reel lift hose
connects to hose (E).
4. Install driveline support (C) to outside of left header
leg with two 3/8 x 3/4 carriage bolts and flange
nuts as shown.
5. Attach driveline supplied with adapter to header
sickle drive shaft. Secure clamp yoke to shaft with
1/2 NC hardware provided.
For storage, attach other end of driveline to anchor
(C).
ATTACH CONTROL BOX
B
Units with fore-aft connect here
INSTALL REEL LIFT HOSE - 962
11”
(280 mm)
F
G
A
C
INSTALL DRIVELINE STORAGE SUPPORT