MacDon 871 Combine Adapter - Manual (Page 42)

42
Adapter Mounting Instructions
for Case IH Combines
PREPARING THE ADAPTER
1. Install feeder house support (C) (from adapter
package) onto the adapter frame with one
1/2 x 1 flange bolt at (D) and three 1/2 x 1
carriage bolts and flange nuts at (E). Repeat at
other side.
NOTE: For attachment to top beam, engage
carriage bolts in keyhole slots.
2. Attach filler (F) with one 1/2 x 1¼ carriage bolt
and flange nut. Repeat at other side.
3. Install lower latch pivot bars (B) in adapter
frame. Ensure pivot pin is installed inside frame
in high position as shown.
4. Feed auger is shipped in forward position. Best
feeding occurs with auger in rearward position,
however dust shield across top of feeder house
opening must be removed to ensure adequate
clearance for this auger position.
To adjust auger position:
a. Loosen bolt (G), both sides.
b. Remove bolt (H), both sides and swing auger
to desired position.
c. Replace and tighten hardware.
D
E
C
F
B
INSTALL ADAPTER COMPLETION PARTS
MOVE FEED AUGER TO REARMOST POSITION
WITH FEEDER HOUSE DUST SHIELD REMOVED