MacDon 871 Combine Adapter - Manual (Page 38)

38
PUMP IN WORKING POSITION
Adapter Mounting Instructions
for John Deere Combines
ATTACHING ADAPTER TO COMBINE (continued)
4. Install pump as follows:
a. Remove pump from storage position (A) on
adapter and slide pump onto R/H feeder house
output shaft.
NOTE: The first time the pump is installed,
hoses may have to be loosened for proper
alignment. Tighten hoses after installation.
b. Engage pump torque arm on support arm on
adapter and secure with lynch pin at (B).
NOTE: For 9650 combine, ensure torque arm
(C) with 2 bends has been added to pump
assembly. See page 35, Step 1.
6. Tighten combine feeder chain and check
clearances. See page 36, step 6.
PUMP STORAGE ON ADAPTER
A
COMBINE TO HEADER CONNECTIONS CONTOUR MASTER & 50 SER. LEVEL LAND