MacDon 871 Combine Adapter - Manual (Page 29)

29
ATTACHMENTS
PLASTIC WEAR STRIP
WholeGoods order no: B2896 – Case, Gleaner, NH TR
B2897 – John Deere, Cat, NH TX
For use in conditions where soil adheres to steel. Plastic
wear strip attaches to feed pan skid plate. Installation
instructions are included with kit.
HEADER HEIGHT CONTROLLER
WholeGoods order no: B2898 – Case 2100 & 2300 Series
B2899 – John Deere 9500, 9600 & CTS Series
For use in conjunction with Auto Header Height Control option on combines, this attachment sends a signal
to the combine to allow maintaining a consistent cutting height as the header follows ground contours.
ASSEMBLY
INSTALL 962 HEADER COMPLETION PARTS
NOTE: This section applies to Model 962 Header
only.
1. Deck backsheet extensions (C) and (D) are
shipped with the Combine Adapter. These are
installed at the delivery opening.
Install extension (C) on left side of delivery
opening and (D) on right side. Extensions mount
to rear of deck backsheet with 3/8 x 3/4 bolts and
flange locknuts. Install hardware with bolt heads
on draper side.
2. Retainers (E) are shipped with the Combine
Adapter. These are installed inside header
center legs to secure header to adapter when
full float is reached. Retainers also restrict
side movement.
Install retainer (E) at inside of left center leg,
using existing 0.41 x 0.81" slot. Secure with
3/8 x 3/4 carriage bolt (F) and flange locknut
(G). When tightening, ensure that header pin
fits freely through leg and retainer at (X).
NOTE: L/H leg is shown. Retainer (E) mounts
to leg side wall closest to center delivery
opening. Left and right retainers (E) are
different. Be sure they are correctly
positioned.
Repeat at right center leg.
PLASTIC WEAR STRIP