Opticon PX 20 v3791A Bluetooth demo Quick Guide - Manual (Page 7)

6
If you want to use a different PIN code, or if you are only allowed to enter a random PIN code
on your device, then you will have to enter this PIN code using direct input labels below.
These labels can be found in the Universal Menu Book as well. After scanning each number
of the PIN code, scan the END label to send the PIN code to the remote device.
When executed correctly your device should now be connected and you should be allowed to
scan and transmit barcodes into any document or application that accepts keyboard input. If
the remote device does establish the pairing, but doesn't automatically connect, you might
have to manually connect afterwards by pressing the trigger key for 5 seconds.
To manually end a connection you can press the clear key for 5 seconds to disconnect your
device.
If you've lost your connection, then your device will try to reconnect automatically for about 1
minute, but if that fails you can reconnect manually by pressing the trigger key for 5 seconds.
The trigger key allows you to reconnect without having to enter the PIN code again as long as
the remote device doesn't lose the pairing information and the OPN200x / PX20 wasn't reset
to default (or the remote Bluetooth address was
n’t changed).
If the pair was ever lost or you want to connect to another remote device you will have use the
clear key again to make your device connectable and allow the remote device to connect and
pair with it.