Memorizing, Other features, Other opn2005 / opn2006 / px20 applications – Opticon PX 20 v3791A Bluetooth demo Quick Guide User Manual
Page 13: Iosoff, Zz_ _batt_ _zz

12
_+-IOSOFF-+_
Enable iPhone/iPad mode Disable iPhone/iPad mode
Read one of the labels above to enable/disable iOS compatibility.
Memorizing
This application supports memorizing of barcodes in case the OPN200x or PX20 loses its
connection with a remote Bluetooth device. This will allow barcodes scanned to be saved in in
memory and be transmitted when a connection is re-established.
If memorizing is desired, see Section 2.3.8 of the Universal Menu Book.
Other Features
The OPN200x/PX20 will show an orange LED 10 times for 1 minute when the battery is too
low for normal operation. After this, the device will shut off automatically. If this indicator is
seen, it is imperative that the device be attached to USB to charge the battery.
The current battery percentage level can be checked by sending the following serially:
When the device is in Bluetooth VCP or USB-VCP mode. In HID mode, the following codes
can be scanned:
_ZZ_
_BATT_
_ZZ_
Other OPN2005 / OPN2006 / PX20 applications
Besides this Bluetooth demo application there are 3 other applications available on our
website that might fit your specific use case better.
Software V3727x: OPN2001 simulation demo application
This application turns the OPN200x/PX20 into an OPN2001 compatible batch scanner.
Besides USB, any stored barcode data can also be retrieved from the barcode scanner by
using Bluetooth.
Use this application in combination with the OPN2001 Demo application for Windows (or
develop your own application using the SDK that's available for the OPN2001).
Note: When planning to use the OPN2005 solely as a standard OPN2001, without Bluetooth
or the need to run other applications, please note the following (hardware) differences:
The OPN2005/6 does not support laser aiming (laser dot) currently
The OPN2005/6 cannot change its scan angle to shorten the laser line currently