Barco R9002327 - Manual (Page 33)

POWER CONNECTION POWER CONNECTION
POWER
CONNECTION
6-3
POWER
CONNECTION
6-3 5975069A BARCOVISION 708 200498 5975069A BARCOVISION 708 200498
Switching on/off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image displayed) or in the 'stand
by mode', depending on the position of the 'power up' dip switch on the controller unit.
This DIP switch is set during installation by a qualified technician. If you want to change
this start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector in operational mode
red : projector is in stand by.
-9V SF HOLD
DOWN
EHT
STANDBY -CONV -17V +17V +HTHD +CONV +9V +210V +30V
LEDs on the front plate of the projector
Switching on/off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image displayed) or in the 'stand
by mode', depending on the position of the 'power up' dip switch on the controller unit.
This DIP switch is set during installation by a qualified technician. If you want to change
this start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector in operational mode
red : projector is in stand by.
-9V SF HOLD
DOWN
EHT
STANDBY -CONV -17V +17V +HTHD +CONV +9V +210V +30V
LEDs on the front plate of the projector
123
123 COINC HOLD
DOWN
HD
123
123 COINC HOLD
DOWN
HD