Multiquip MG30M2D - Manual (Page 36)

PAGE 36 — MAYCO MG-30 PUMP — OPERATION AND PARTS MANUAL — REV. #3 (09/15/11)
MG-30 PUMP — PRE-INSPECTION (PUMP)
CAUTION CAUTION CAUTION CAUTION CAUTION
NEVER operate the pump in
a confined area or enclosed
area structure that does not
provide ample free flow of air .
ALWAYS wear approved eye and hearing
protection before operating the pump .
NEVER place hands or feet inside the
hopper . ALWAYS make while the engine is running. ALWAYS
shut-down the engine before performing any kind of maintenance
service on the pump.
NEVER operate the pumps's engine with the
engine hood removed. The possibility exists of
hands , long hair , and clothing becoming
entangled with the V-belt, causing injury and
bodily harm.
Before Starting
1. Read safety instructions at the beginning
of manual.
2. Clean the entire pump , removing dirt and dust, particularly
the engine cooling air inlet, and air filter.
3. Check the air filter for dirt and dust. If air filter is dirty, replace
air filter with a new one as required.
4. Check fastening nuts and bolts for tightness.
FUEL CHECK
1. Read the fuel gauge (Figure 24) on top of the fuel tank to
determine if the pump's engine fuel is low . If fuel is low, fill
with
#2 diesel fuel (Figure 25).
See Figure 11 on page 28 for the location of any control or
component referenced in this section.
Figure 24. Fuel Gauge (Pump)
CAUTION:
Handle fuel safely. Diesel fuel is highly
flammable and can be dangerous if
mishandled. DO NOT smoke while refueling.
DO NOT attempt to refuel mixer if the engine is
hot or running.
ALWAYS allow engine to cool
before refueling.
ENGINE OIL CHECK
1. Remove the engine oil dipstick from its holder (Figure 26).
Figure 25. Adding Diesel Fuel
Figure 26. Engine Oil Dipstick