Mg-30 pump — pre-inspection (mixer), Caution – Multiquip MG30M2D User Manual

Page 33

MAYCO MG-30 PUMP — OPERATION AND PARTS MANUAL — REV. #3 (09/15/11) — PAGE 33

MG-30 PUMP — PRE-INSPECTION (MIXER)

Reference manufacturer engine
manual for specific servicing
instructions.

CAUTION:

Handle fuel safely. Motor fuels are highly

flammable

and can be dangerous if

mishandled. DO NOT

smoke

while refueling.

DO NOT attempt to refuel mixer if the engine is
hot or running.

ALWAYS

allow engine to

cool

before refueling.

ENGINE OIL

Remove the engine oil dipstick from its holder (Figure 16).

Figure 15. Adding Diesel Fuel

Figure 16. Oil Filler Port/Dipstick

NOTE

CAUTION

NEVER operate the mixer in
a confined area or enclosed
area structure that does not

provide ample

free flow of air

ALWAYS wear approved

eye

and

hearing

protection before operating the mixer.

NEVER place hands or feet inside the mixing
drum.

ALWAYS

make sure the

safety grill

on the mixer is locked while the engine is
running. ALWAYS shut-down the engine
before performing any kind of maintenance
service on the mixer.

Before Starting

1. Read safety instructions at the beginning

of manual.

2. Clean the

entire mixer

, removing dirt and dust, par-

ticularly the engine cooling air inlet, and air filter.

Check the

air filter

for dirt and dust. If air filter is dirty,

replace air filter with a new one as required.

Check fastening nuts and bolts for tightness.

FUEL

Lift the fuel cap latch located on top of the fuel tank then look
inside the tank and determine if the mixer's engine fuel is
low . If fuel is low, fill with

#2 diesel fuel

(Figure 15). See

Table 4 for other types of recommended fuel.

See Figure 12, page 30 for the location of any control or
component referenced in this section.

This manual is related to the following products:

MG30T2D