MTS ReNew Technical Reference - Manual (Page 34)

ReNew Technical Reference 34
Handset Control
Operation
Handset functions
The handset is intended to be used in a system for specimen loading or setup. In
some applications, it can be used to completely run a test.
Handset Controls and Indicators
# Control/Indicator Description
1 Page Displays the next four lines of text in the display.
2 Active Indicator. When lit, indicates the system is active (power
applied).
3 F1 and F2 Programmable functions that are set up in the software as
digital inputs. This allows you to define the test function (that
is, start test, pause, hold position, and so forth).
4 Thumb-wheel Makes fine crosshead adjustment (towards display – up; away
from display – down. Only if Handset Enable is active.
5 Pause Pauses the test action. This must be pressed again for the test to
resume. Only if TestWorks 4 software is active.
6 Stop Stops the test action. Only if TestWorks 4 software is active.
7 Connector RJ-45, to Controller.
8 Crosshead Return Returns the crosshead to the original position (zero point).
9 Start Starts the test action. Only if TestWorks 4 software is active.
10 Crosshead Down Moves the crosshead in the downward direction while
depressed. Only if Handset Enable is active.
11 Crosshead Up Moves the crosshead in the upward direction while depressed.
Only if Handset Enable is active.
12 Fault Indicator. When lit, indicates and active fault or interlock.
13 Handset enable Used to enable/disable the handset. When the indicator is lit,
the handset is enabled for control of the crosshead.
14 Display Four lines, 20 characters per line.