MTS ReNew Technical Reference - Manual (Page 27)

ReNew Technical Reference Installation 27
J8—DC Conditioner 2. Could be strain based extensometer, second load cell, or
high level analog output sensor. Typically Strain 2 in TestWorks 4.
J9—DC Conditioner 1. Could be strain based extensometer, second load cell, or
high level analog output sensor. Typically Strain 1 in TestWorks 4.
J10—Mongoose AC Pwr Cntrl. This input control AC power for Elite and SMA
chassis.
J11—Digital I/O Input. this I/O is used to enable low and high clutches using D I/
O 3.
J12—DC Cond 3 QFCC/Sable. This input is used as an input for load cell signals
for QFCC and Sable ReNew systems.
J13—DC Cond 3 Mongoose. This input can be used to route load cell signals for
some Mongoose ReNew systems.
J1 USB
This is a standard USB 2.0 connector that accepts a USB-B cable connector and
connects to the computer. This provides a communications interface between
TestWorks on the PC and the controller. This is used to allow TestWorks, or other
software, to change settings in the controller. It also allows TestWorks to receive
data from the controller.