Metal Sales Stile Installation - Manual (Page 7)

STILE
6
© Metal Sales Manufacturing Corporation/ Subject to change without notice
SLOPE
SUBSTRUCTURE
The minimum recommended slope for any Stile roofing panel is 3:12.
The recommended substrate is 5 /
8
" plywood with a #30 felt moisture barrier. To
avoid panel distortion, use a properly aligned and uniform substructure.
If your application is over a substrate other than
5 /
8
" plywood, please contact the
Metal Sales location servicing you (refer to page 2).
Each panel has a coverage of 39.4" (1 meter).
Minimum factory cut length is 3'-0". Maximum panel length is 20'-0". Lengths
between 3'-0" and 20'-0" will be cut at 1'-0" increments.
Architectural panel.
Direct Fasten (exposed).
The Fastener Selection Guide (see page 11) should be consulted for choosing
proper fasteners for specific applications. Quantity and type of fastener must meet
necessary loading and code requirements.
Stile panels are available in 26 Gauge Galvanized (G-90) coating.
Stile panels are available in limited Fluorocarbon (PVF2)* finishes. See Stile
brochure for color selection.
*Meets both Kynar 500 and Hylar 5000 specifications.
COVERAGE
LENGTH
FASTENING SYSTEM
APPLICATION
PANEL OVERVIEW
MATERIALS
FASTENERS
PANEL ISOMETRIC
FINISHES