Stile, Storage – Metal Sales Stile Installation User Manual

Page 19

STILE

GENERAL

STORAGE

FOOT TRAFFIC

Please inspect panels for moisture accumulation. If moisture has formed, the panels should be un-

bundled, wiped dry, and allowed to dry completely. Once dry, carefully restack the panels and loosely

recover allowing for ample air circulation.

Bundled sheets should be stored high enough off of the ground to allow for air circulation and prevent

contact with accumulating water. If possible, elevate one end of the bundle to allow any moisture to

run off the panels. Metal Sales recommends covering the bundle with a tarpaulin. Do not use tight

fitting plastic-type tarpaulins as panel bundle covers. While they may provide protection from heavy

downpours, they can also retard necessary ventilation and trap heat and moisture that may accelerate

metal corrosion. If panels are to be stored in possible bad weather, we suggest they be stored inside.

Extended storage of panels in a bundle is not recommended. Under no circumstances should the

sheets be stored near or come in contact with salt water, corrosive chemicals, ash or fumes

generated or released inside the building or nearby plants, foundries, plating works, kilns,

fertilizer, and wet or green lumber.

Care of metal panels and flashings must be exercised throughout erection. Foot traffic can cause

distortion of panel and damage to finish. Traffic over the installed system must be kept to an absolute

minimum. Installers should wear rubber sole shoes to keep from scuffing material while walking on

the roof.

CAUTION

Avoid walking on

panels when wet.

FOOT TRAFFIC

STILE PANEL