Metal Sales Stile Installation - Manual (Page 30)

STILE
29
© Metal Sales Manufacturing Corporation/ Subject to change without notice
INSTALLATION OF FORMED RAKE
RIGHT FORMED RAKE
RAKE CONDITION
1. After the Stile panel has been installed in the opening of the Rake Starter, fasten the upper leg of the
Rake Starter to the Stile panel rib with a 1 /
8
" Pop Rivet.
2. Pop Rivets are placed directly over the high point of the panel at each step.
3. Starting at the eave install the Formed Rake over the Rake Starter. The lip on the top
flange of the Formed Rake fits over the top leg of the Rake Starter.
4. Rotate the Formed Rake down so that the lower flange extends down onto the rake board or siding.
5. Attach the bottom flange of the Formed Rake with a Woodscrew XL fastener below each step on the
flashing. The last step of the flashing should not be fastened until the next piece of Formed Rake is
overlapped.
6. At the peak of the rake, the two pieces of Formed Rake will need to be cut at an angle so they fit
neatly together. Apply Tube Sealant where the Formed Rake flashings meet each other and fasten
with three 1 /
8
" Pop Rivets.
POP RIVET
RAKE STARTER
WOODSCREW XL
STILE CLOSURE
EAVE FLASHING
WOODSCREW XL
RAKE STARTER
FORMED RAKE
POP RIVET
STILE PANEL
LEFT FORMED RAKE