Memmert ICH 256 Climate Chambers (Generation 2003) User Manual

Page 3

About this Manual

Purpose and target group

This manual describes the assembly, function, transport and operation of ICH 256 cooled

incubators. It is intended for use by personnel trained by the operator, who have the task of

operating and/or maintaining the cooled incubator.
If you are asked to work on the cooled incubator, read this manual carefully before starting

work on the unit. Familiarise yourself with the safety regulations. Only perform work that is

described in this manual. If there is something you do not understand, or certain informa-

tion is missing, ask your superior or contact the manufacturer. Do not do anything without

authorisation.

Contents

The ICH 256 cooled incubator is available with different configurations: If specific equipment

features or functions are available only with one of the configurations, this is indicated at the

relevant points in this manual.
Due to individual configurations, depictions in this manual may be different from the actual

appearance.

Other documents that have to be observed:

►

For control of the cooled incubator with the Memmert PC software “Celsius“, please refer

to the enclosed, separate manual.

►

For service and repair work (see page 68 ), please refer to the separate service manual.

Storage and forwarding

This instruction manual belongs to the cooled incubator and should always be stored where

persons working on the appliance have access to it. It is the responsibility of the owner to

ensure that persons who are working or will work on the appliance are informed as to the

whereabouts of this instruction manual. We recommend that it is always stored in a protected

location close to the cooled incubator. Make sure that the instruction manual is not damaged

by heat or humidity. If the cooled incubator is sold on or transported and then set up again at

a different location, this manual must also go with it.