Lenze E94AxHE Technology Application Positioning sequence control - Manual (Page 39)

EDS94TA10060xxxx EN 1.2 - 03/2010
L
39
9400 Technology applications | Positioning sequence control
Parameter setting & configuration
Program flow
5.3.4 Action type "Variable branching"
For variable branches (jumps) 5 actions of type "Variable branching" are available for the
sequence table.
[5.1] Principle of the variable branch (here for action no. 1)

Tip!
Instead of the parameters C03001 ... C03005 you can also assign other signal
sources of the application to the "branch" inputs via multiplexer parameters.
 Parameter setting: Tab Application parameters  dialog level Overview  Sequence
control
 The branch to one of 20 possible steps
is executed in the Lenze setting
depending on the value in
C03001 ... C03005 at the time or
processing.
 The parameters C03001 ... C03005 are
firmly assigned to the five available
actions, i.e. C03001 determines the
branch for action 1, C03002 for
action 2, etc.
1
n
2
>20
1 2 20
Following
step
Next step Next step Next step
C04540/1 C04541/1 C04559/1
Branch 1 value
C03001
<1
Parameter Lenze setting
Value Unit
C03001 Branch value 1 1
C03002 Branch value 2 1
C03003 Branch value 3 1
C03004 Branch value 4 1
C03005 Branch value 5 1
Control inputs of the function Signal configuration
Lenze setting Control input (Multiplexer parameters)
C03001  Sequencer branch 1 C03079/1
C03002  Sequencer branch 2 C03079/2
C03003  Sequencer branch 3 C03079/3
C03004  Sequencer branch 4 C03079/4
C03005  Sequencer branch 5 C03079/5