Landoll WFPC22-36 Wing Float Pulverizer - Manual (Page 16)

2-2 F-701
ASSEMBLY
Frame and Transport Axle Assembly
1. Select a smooth, level area that can be reached by a
hoist or lift truck.
2. Place the Center Frame on supports, approximately
36 inches high and rated for 2,000 lbs. or higher.
3. Attach Transport Axle to Center Frame, using 5/8-11
x 11 1/2" HHCS, Flat Washers, and Lock Nuts.
NOTE
The Plastic Bearings are maintenance free and require
no grease.
• Install the base end of the 3 1/2 X 16 Hydraulic
Cylinder using one of the pins provided with the
Cylinder. The rod end of the Cylinder will be attached
to the Lift Linkage at the same time as the linkage.
See Figure 2-2.
• Tighten all hardware to the recommended torques.
See Page 4-1.
Figure 2-1: Frame and Transport Axle Assembly
HHCS,5/8-11 x 11-1/2
Transport Axle Asm
Bearing Half
Bearing Insert
Nut,Lock
5/8-11
Bearing Half
Center Frame
HHCS,5/8-11 x 11-1/2
HHCS,5/8-11 x 11-1/2
Flat Washer, 5/8
Flat Washer, 5/8
Flat Washer, 5/8