Kisan Electronics SN-5 - Manual (Page 34)

Page-32
NOTE! BOTH front and rear turn signal bulbs will flash during this short
interval – just as they flash together for turn signals. They are wired
together on the bike.
BMW models with ABS brakes do not allow successive brake
applications to generate 12V distinctly, which is necessary for the
programming sequence.
You can use the Brake Input wire as a direct input to any 12V source
and perform the programming procedure described above.
DUAL handlebar switch applications:
SAME-SIDE CANCEL FEATURE:
Once the flashing has begun on either side, push the same side switch to
cancel. This is much easier than using the right handlebar Cancel switch.
LANE CHANGE - FAST FLASH MODE:
(Does not apply if the you have selected 45 second extended time-out)
Hold down the turn signal switch to start quick flash of initial 5 flashes
4-WAY EMERGENCY FLASH MODE:
For BMW models, both SM-5 and SM-6 permit activation of the 4-Way
emergency flashing by pushing down both right and left turn signal switch
simultaneously.
To end 4-Way flashing, push-up the Cancel switch on the right handlebar
BRAKE FLASH FEATURE:
(Brake Input wire must be hooked-up)
As long as the turn signals are NOT ACTIVE, applying the brakes makes turn
signal bulbs to flash as brakes. The flash pattern begins with fast flash rate,
which slows down to solid ON after 2 ½ seconds.
„ This feature deactivated as a factory default.
PROGRAMMING BRAKE FLASH FEATURE:
X
Apply & Hold brakes first, then turn ignition on.
Y
Immediately begin pumping the brakes at least 6 to 8 times
„ This is a toggle function – it activates it on or off upon each execution