Lever activated dual-pole switch – Kisan Electronics SN-5 User Manual
Page 30
Page-28
Lever Activated Dual-Pole Switch
:
(Chrome Covered)
This is the most commonly found internal switch. It is applicable for most
Japanese bikes.
When moved in either direction, one pole is disconnected while the other
is connected.
The lever returns to center but the electrical switch remains latched. The
lever must be pushed-in to release the latch.
The internal switch and the lever
mechanism do not have to be
removed from the housing.
As you move the lever from side to
side, note the motion of the white
plastic slider. An empty cavity is
created to allow insertion of the return
springs.
Using small needle-nose pliers or
tweezers, insert metal springs such
that the larger base is towards the
center of the switch, as shown here.
After inserting springs or foam plugs
make sure the switch has full motion and
makes proper contact.
Verify that the turn signals are
activated in both directions before
reinstalling the housing back on the
handlebar.