Kisan Electronics SN-5 - Manual (Page 21)

Page-19
SM-4 INSTALLATION:
On most models, access to
the turn signal flasher is
possible simply by removing
the seat and locating it within the wiring harness underneath.
On some models, it is located inside the front fairing. If in doubt, turn it on
and follow the clicking sound to locate it.
Refer to your bike’s Manual, or the Wiring Diagram to find its location.
TO INCREASE TIME, after which the signalMinder will stop flashing:
n
Make sure the power is turned OFF.
o
Set the time-out by appropriate selection of the DIP switch
To install other optional features, please refer to:
„ Optional Hook-ups section
„ Special Features and Functions
„ VL-10 vectraLIGHT plug-in ports
Enhance your visibility! – Use all available features.
„ The 4-Way flash or Test Mode flash features are not enabled
unless the Running Light Option is hooked-up.
„ After hook-up, you can turn the Running Lights Off with DIP switch
TYPICAL LOCATION