Kisan Electronics SN-5 - Manual (Page 25)

Page-23
SM-6 INSTALLATION:
Typical signal flashers:
† BMW# 1 459 224
† Siemens# 72BB401
On most K-1200LT models, the turn signal flasher is located inside the relay
panel – underneath the gas tank. To gain access to it, remove “C” clips or
10mm bolts to lift the tail end of the gas tank.
For older K-series, the relay box can be found under the seat.
signalMinder is much smaller than the original relay, so it will have to be
mounted on the sidewall of the fuse-box with the Velcro strip supplied.
ON-THE-FLY PROGRAMMIMG TIME-OUT
Push and HOLD LEFT
Turn signal switch button
Then turn the
Ignition ON
45 Seconds
Push and HOLD RIGHT
Turn signal switch button
Then turn the
Ignition ON
30 Seconds
Push and HOLD CANCEL
Turn signal switch button
Then turn the
Ignition ON
8 Seconds
When you PUSH and HOLD any of the turn signal switches and then turn
the Ignition ON, the turn signal lamps will light up to validate setting change.
1
st
Time Low Intensity
2
nd
Time Turn Lights Off
ADJUSTING RUNNING LIGHT
INTENSITY
Push and HOLD CANCEL
Then push Emergency 4-way button
3
rd
Time High Intensity
If you elect to install other optional features, please refer to:
„ Brake Input Option
„ VL-10 vectraLIGHT plug-in ports
Enhance your visibility! – Use all available features.