Kisan Electronics SN-5 - Manual (Page 15)

Page-13
Remove the seat and locate the fuse box.
The 8-pin replay is usually right next to it.
n Cut the LT. BLUE wire and crimp-on the
OUTPUT to the cut end - which goes toward
the turn signal switch
o Install the Scotch-lock on the ORANGE
wire – it has 12v with ignition ON - and
hookup the small ring for power
p Attach the ground wire with the large ring,
to a suitable location.
SM-3SV INSTALLATION:
INSTRUCTIONS FOR MANY SUZUKI MODELS:
UNIVERSAL APPLICATION – signalMinder WIRES:
OUTPUT = Black wire with crimp-on bullet connector (Flashing Output)
POWER = Red wire with small ring connector (12v w/ignition On)
GROUND = Green wire with large ring lug (chassis ground)
TO INCREASE TIME, after which the signalMinder will stop flashing:
n
Make sure the power is turned OFF.
o
Set the time-out by appropriate selection of the DIP switch
To install other optional features, please refer to:
„ Optional Hook-ups section
„ Special Features and Functions
„ VL-10 vectraLIGHT plug-in ports
Enhance your visibility! – Use all available features.
„ The 4-Way flash or Test Mode flash features are not enabled
unless the Running Light Option is hooked-up.
„ After hook-up, you can turn the Running Lights Off with DIP switch