Kisan Electronics SN-5 - Manual (Page 19)

Page-17
SM-3R INSTALLATION:
† Nippon Denso
INSTRUCTIONS FOR HONDA RUNE:
„ The original signal flasher is located under the left engine cover, which
can be removed by un-snapping the plastic fasteners. Unplug the relay and
hook-up the signalMinder. Reinstall it in the rubber holder.
„ Brake Input wire – Green w/yellow stripe – can be tapped in front of the
gas tank, under the instrument panel cavity.
TO INCREASE TIME, after which the signalMinder will stop flashing:
(10 seconds is factory default setting)
n
Make sure the power is turned OFF.
o
Set the time-out by appropriate selection of the DIP switch
To install other optional features, please refer to:
„ Brake Input Option
„ Special Features and Functions
„ VL-10 vectraLIGHT plug-in ports
Enhance your visibility! – Use all available features.
„ The 4-Way flash or Escort Mode flash features are enabled but
easier to activate with handlebar switch modified.
„ After hook-up, you can turn the Running Lights Off with DIP switch
Mount SM-3R in the
rubber holder