Kisan Electronics SN-5 - Manual (Page 17)

Page-15
SM-3M INSTALLATION:
Modified 3-pins
† Nippon Denso
On most models, access to the turn
signal flasher is possible simply by
removing the seat and locating it
within the wiring harness
underneath.
On some models, it is located inside the front fairing. If in doubt, turn it on
and follow the clicking sound to locate it.
Refer to your bike’s Manual, or the Wiring Diagram to find its location.
TO INCREASE TIME, after which the signalMinder will stop flashing:
n
Make sure the power is turned OFF.
o
Set the time-out by appropriate selection of the DIP switch
To install other optional features, please refer to:
„ Optional Hook-ups section
„ Special Features and Functions
„ VL-10 vectraLIGHT plug-in ports
Enhance your visibility! – Use all available features.
Typically in the tail
section
„ The 4-Way flash or Test Mode flash features are not enabled
unless the Running Light Option is hooked-up.
„ After hook-up, you can turn the Running Lights Off with DIP switch