Kisan Electronics SN-5 - Manual (Page 29)

Page-27
INSTALLING RETURN SPRINGS:
Running Light Option MUST BE hooked-up for this modification.
Installation of the two opposing Return Springs modifies the handlebar
switch for UN-LATCHED operation. signalMinder will automatically detect
the momentary-On switch mode, and allow continued flashing.
Metal Springs are spiral wound.
When you compress, each turn
nests inside the next larger turn.
„ Verify that there’s no
interference by collapsing it fully.
„ Fully compressed, it should
flatten out to height of one wire
diameter.
„ Use Foam plugs as return
springs, if too you have to push
hard to activate the signals.
„ Use Foam plugs if the switch cavity has open bottom and may cause a
short with the metal springs inserted.
REMOVING TURN SIGNAL SWITCH FROM HANDELBAR:
Typically the handlebar switch
assembly is secured around the
handlebar and has a split housing.
„ To remove the handlebar switch,
loosen and remove the screws that
clamp the assembly on to the handle
bar.
„ After the switch assembly is
removed from the handlebar, spread
the two halves apart to gain access to
the back of the electrical switch.
„ signalMinder is configured as dual channel device. When it detects
that the Running Light connections are made, it diverts the current flow
through those left and right channel connections. The handlebar switch
merely acts as a trigger for the right or the left side.