Kisan Electronics SN-5 - Manual (Page 27)

Page-25
This optional feature will turn both the front
and rear turn signal lamps into marker lights.
The additional visibility will
enhance your safety on
the road. If you do not wish
to have the marker lights
on, use DIP Switch #1 to
turn this feature off.
The included wiring harness for installing this
option includes (3) wires installed with a
matching connector and (3) scotch-locks.
Locate following wires on your bike:
ON THE BIKE TEST FOR: CONNECT WITH
Left Turn Signal Flashing 12v Black Wire
Right Turn Signal Flashing 12v White Wire
Brake Wire 12v with Brakes on Red Wire
Typical wire colors for most makes of bikes are shown below. Use a
voltmeter to identify each wire, and choose an appropriate location to snap
the scotch-lock over the wire and then use pliers to squeeze it tight. The
small ring connector must be inserted fully in to the slot of the scotch-lock.
Left Signal Right Signal
Honda Orange Light Blue
BMW Blue/Red Blue/Black
Triumph Green Gray
Suzuki Orange Light Blue
Kawasaki White Black
Yamaha Brown Green
Colors shown are most common for the bikes listed. You should consult your own Manual or
use a multi-meter or test light to verify.
NOTE! The Dash Indicators will remain dimly lit all the time with this
option connected since they are connected in parallel.