Kisan Electronics SN-5 - Manual (Page 33)

Page-31
NOTE! BOTH front and rear turn signal bulbs will flash during this short
interval – just as they flash together for turn signals. They are wired
together on the bike.
NOTE! If your bike is equipped with a separate button for the 4-Way
emergency flash, it will be subject to the Time-Out setting you have
selected. Using the above method overrides the setting.
SPECIAL FEATURES:
SINGLE handlebar switch applications:
Running Light Option MUST BE hooked-up to use the following
options.
SAME-SIDE CANCEL FEATURE:
(Does not apply if the Return Springs are not installed)
Once the flashing has begun on either side, returning the switch to the same
side once more and holding it will cancel it in about ½ second.
4-WAY EMERGENCY FLASH MODE:
(
After each right turn, push reset to center the switch, if the Return Springs are not installed)
Flick the turn signal switch (4) times to the RIGHT- about once a second.
To end 4-Way flash, move switch one more time to the RIGHT and hold.
ESCORT FLASH MODE:
(
After each right turn, push reset to center the switch, if the Return Springs are not installed)
Flick the turn signal switch (4) times to the LEFT – about once a second.
„
To end flashing, move switch one more time to the LEFT and hold
BRAKE FLASH FEATURE:
(Brake Input wire must be hooked-up)
As long as the turn signals NOT ACTIVE, applying the brakes makes turn
signal bulbs to flash as brakes. The flash pattern begins with fast flash rate,
which slows down to solid ON after 2 ½ seconds.
„ This feature is active as a factory default. It is programmable feature. You
can activate it or deactivate it. Follow the programming procedure described
on next page.