beautypg.com

Installation overview, Please read back of this page before installation – Kisan Electronics SN-5 User Manual

Page 3

background image

Page-1

INSTALLATION OVERVIEW:



signalMinder

is a 100% solid-state device, which replaces the existing turn

signal relay of your bike - in many cases this a simple plug-in procedure. But
depending on your bike, you may need additional hook-up.


„ Locate the original turn signal
flasher and replace it with
appropriate signalMinder - attach
ground wire if needed.

This basic step will provide
cancellation with 3 selectable
timeouts.


However, to utilize all of the built-in features of the signalMinder, following
steps are needed.


„ Locate right & left turn signal wires and brake
wire of the bike and tap into them with Scotchlock
T-Tap connectors supplied.

(Refer to pages 24 – 26)


This step will enable:
n Running Lights – front and rear
o 4-Way emergency flash and Escort mode flash
p Brake override and Brake flash feature



Finally, for bikes with a SINGLE handlebar switch requiring Push-to-Cancel
to bring the switch back to neutral, next step is needed.


„ Remove the turn signal switch from the

handlebar and install either metal springs or
foam plugs so that it returns to neutral.

(Refer to pages 27 – 30)


This step of modifying the handlebar switch
transforms the bike to a fully automatic turn
signal cancellation system.

Please read back of this page before installation.

This manual is related to the following products: