JUMO 707060 Wtrans B - Programmable Head Transmitter with Radio Transmission Operating Manual - Manual (Page 35)

35
7 Setup program
Term definition
Probe ID
The probe ID is an unmistakable ID with max. 5 characters which is recognized by the receiver.
The ID can be individually changed, for example, to achieve a better overview of a system. En-
sure that an ID is not used simultanously by two probes within the reception range to avoid mal-
functions.
Transmission interval
This parameter is used to define the time intervals used to transmit data to a receiver. The set-
ting of the "Transmission interval" parameter affects the battery service life. For this reason, act
with caution and do not only consider the transmission quality when selecting the interval.
Transmission frequency
The transmission frequency defines the frequency band used to transmit data to a receiver. The
transmission frequency is defined at 868.4 MHz for Europe because special regulations are de-
fined concerning transmission interval and transmission capacity for the ISM band (Industrial,
Scientific and Medical Band).
TAG number 10-digit number, freely selectable
Information text 10-digit number, freely selectable
Installation date current date any date
Parameters Factory setting Value range/Selection 
TIP!
At a transmission interval of > 15 s, the probe transmits a so-called link telegram (after a set-
up transmission), i. e. the telegrams are transmitted at the factory-set interval of 15 s for a
period of 30 minutes, and only then at the set transmission interval.
TIP!
Once the setup connector is connected, the probe automatically transmits telegrams at a
transmission interval of 1s to ensure that changes can be immediately detected by the receiv-
er. After the setup connector is removed, the telegrams are transmitted again at the set trans-
mission interval.