JUMO 707060 Wtrans B - Programmable Head Transmitter with Radio Transmission Operating Manual - Manual (Page 27)

27
7 Setup program
7.1 General information about the setup program
The setup program serves to configure probes and receivers by means of a PC. The configu-
ration data can be archived on data carriers and printed.
Configurable parameters are:
•
Probe ID
• Transmission interval
• Configuration of the probe used
The factory settings are:
•
Probe ID consecutively
• Transmission interval (15s)
• Probe setting as per order specifications
(Example: Pt100 in 3-wire circuit, -200 ... +600 °C)
The connection between probe and PC is established via a PC interface (USB/TTL or TTL/
RS232 converter).