JUMO 705020 mTRON T - Analog Input Module, 4-Ch. Operating Manual - Manual (Page 45)

45
6 Configuration
6.4 NV connecting list
The NV connecting list is used to link external inputs (NV_...) of the analog input module 4-
channel to signals from other modules via the system bus.
A comprehensive list with the module signals is included in the following chapter.

Chapter 6.4.1 "Digital signals (overview)", page 47
Further information about the signals can be found in the operating manual for the relevant
module.
Replacement values are available in the event that these signals are not available (connection
to base unit interrupted in "Stop" state).

Chapter 6.4.2 "Replacement values (overview)", page 52
Setup dialog
Parameter
TIP!
There is no NV connecting list in the input/output module configuration menu on the multi-
function panel. Instead, a central NV connecting list is available in the configuration menu of
the base unit (CPU).
Parameter Selection/settings Description
Digital signal /
Value Select input to be connected. List of external inputs of the module
If a connection has already been config-
ured, the module and its signal are dis-
played in the "Value" column.