JULABO LC 6 Programmable Controller - Manual (Page 50)

Cleaning / repairing the unit
50
12. Cleaning / repairing the unit
Caution:
Improper maintenance or repair can result in electric shock or damage to the unit.
 Repairs and any other work are to be carried out only by qualified service
personnel authorized by JULABO.
 Always turn off the unit and disconnect the mains cable from the power
source before performing any service or maintenance procedures, or before
moving the unit.
 Prevent humidity from entering into the unit.
Cleaning:
The controller is designed for continuous operation under normal
conditions. Periodic maintenance is not required.
Clean the outside of the unit using a wet cloth and low surface
tension water.
Repairs:
Before asking for a service technician or returning a JULABO
instrument for repair, please contact an authorized JULABO service
station.
Returning a unit: When returning the unit:
 Clean the unit and, if necessary, decontaminate the unit in order
to avoid endangering service personnel.
 Attach a short fault description.
 During transport the unit has to stand upright. Mark the packing
correspondingly.
 When returning a unit, take care of careful and adequate packing.
 JULABO is not responsible for damages that might occur from
insufficient packing.
JULABO reserves the right to carry out technical modifications with
repairs for providing improved performance of a unit.