JULABO LC 6 Programmable Controller - Manual (Page 20)

Manual operation
20
7. Manual operation
7.1. Start - Stop
Start:
 Press the start/stop key
.
The MULTI-DISPLAY (LED) indicates the actual bath
temperature. (example: 21.03 °C)
Stop:
 Press the start/stop key
.
The MULTI-DISPLAY (LED) indicates the message "OFF".
 The unit also enters the safe operating state "OFF" or "r OFF after a mains power
interruptance. The temperature values entered via the keypad remain in memory.
With the programmable controller in keypad control mode, press the start/stop key
to restart operation.
With the programmable controller in remote control mode, the personal computer
must first resend the parameters set via the interface before the circulator may be
restarted.
7.2. Setting the temperatures
This setting may be carried out with the programmable
controller being in operating state Start or Stop!
Setting the working temperature "T1":

Press the setpoint key .
The value previously set appears on the DIALOG-
DISPLAY (LCD) (example: 50.00°C).
A flashing segment indicates that a value needs to be
entered.

Use the keypad to enter the new value (example: 37.00
°C).

Press enter to store the selected value.
Setting the working temperature "T2":

Press the setpoint key .

Follow the instructions

for "T1" (example: 25.50 °C).