JULABO LC 6 Programmable Controller - Manual (Page 47)

47
Command Parameter Response of programmable controller
in_mode_04 none Internal/external temperature control:
0 = Temperature control with Pt100 sensor „INT“.
1 = Temperature control with Pt100 sensor „EXT“.
in_mode_05 none Circulator in Stop/Start condition:
0 = Stop
1 = Start
in_par_01 none Time constant of the external bath.
in_par_02 none Internal slope.
in_par_03 none Time constant of the internal bath.
in_par_04 none Band limiting (max. difference between the temperatures in
the internal bath and external system).
in_par_05 none Ratio for max. cooling power versus max. heating power.
in_par_06 none Xp control parameter of the internal controller.
in_par_07 none Tn control parameter of the internal controller.
in_par_08 none Tv control parameter of the internal controller.
in_par_09 none Xp control parameter of the cascade controller.
in_par_10 none Proportional portion of the cascade controller.
in_par_11 none Tn control parameter of the cascade controller.
in_par_12 none Tv control parameter of the cascade controller.
out commands: Setting parameters or temperature values.
Command Parameter Response of circulator
out_mode_01 0 Use working temperature "T1"
out_mode_01 1 Use working temperature "T2"
out_mode_02 0 No identification.
Temperature control by using the stored parameters.
out_mode_02 1 Single identification of controlled system after the next start.