JULABO LC 6 Programmable Controller User Manual

Page 31

8.3.1. Interrupting a profile

Interrupting a profile:

Press the start/stop key

to interrupt or restart a profile.

The setpoint and time period set for the corresponding section
are thus stopped at the values presently achieved.
The programmable controller is put on hold and the message
„pause“ flashes on the DIALOG DISPLAY (LCD).

STAND-BY

 A profile can be interrupted or restarted by an external

emergency shut-off.(see page 6).

CAUTION:

This is not an actual emergency shut-off!

 The setpoint control and the timer are interrupted by

breaking the contact “AK”. The programmer switches to the
waiting position, while displaying this condition with a
blinking LCD display.

Important:
To achieve this, the Stand-by condition must first be
activated and the Autostart function turned on.
(see page 27).

Warning:

Following a power interruption, it would be possible in this condition for the
programmer to restart automatically. The safety and warning functions of the
programmer should always be used to their fullest capacity.

See warning page 27

Termination of a profile:

A profile can be terminated by pressing the escape key

The programmer switches back to the Start menu.

 Press escape

again to leave the menu or use the

cursor keys

to remain in the Start menu.

The execution of another temperature profile can now be
prepared if necessary.