JULABO LC 6 Programmable Controller - Manual (Page 19)

19
6. Operating procedures
6.1. Power connection
Caution:
 Only connect the unit to a power socket with earthing contact (PE – protective
earth)!
 The power supply plug serves as safe disconnecting device from the line and
must be always easily accessible.
 Never operate equipment with damaged mains power cables.
 Regularly check the mains power cables for material defects (e.g. for cracks).
 We disclaim all liability for damage caused by incorrect line voltages!
Make sure that the line voltage and frequency match the supply
voltage specified on the type plate.
Deviations of ±10 % are permissible.
6.2. Switching on / Selecting the language
Switching on:
Turn on the mains power switch.
The unit performs a self-test.
All segments of the 5-digit MULTI-DISPLAY (LED), all
indicator lights and the DIALOG-DISPLAY (LCD) will
illuminate.
Then the software version (example: n 1.11) appears. The
display "OFF" indicates the unit is ready to operate (standby
mode).
The programmable controller enters the operating mode
activated before switching the programmable controller off:
keypad control mode (manual operation) or
remote control mode (operation via personal computer).
Selecting the language:
There are two options for the language of the DIALOG-
DISPLAY (LCD): German or English. Select the desired
language in the MENUE level under the configuration
submenu.
Press the respective keys in the following order:
1. MENUE key 1 x
2. Enter key 1 x
3. Cursor key 4 x
4. P key 1 x
5. Enter key 1 x
6. Escape key 2 x
The DIALOG-DISPLAY (LCD) helps to follow up the
individual settings. (example: swap the language from
German to English.)