JULABO LC 6 Programmable Controller - Manual (Page 48)

Remote control
48
Command Parameter Response of circulator
out_mode_02 2 Continual identification of controlled system whenever a new
setpoint is to be reached.
out_mode_04 0 Temperature control with Pt100 sensor „INT“.
out_mode_04 1 Temperature control with Pt100 sensor „EXT“.
out_mode_05 0 Stop the programmable controller = r OFF.
out_mode_05 1 Start the programmable controller.
out_sp_00 xxx.x Set working temperature "T1".
out_sp_01 xxx.x Set working temperature "T2".
out_sp_03 xxx.x
Set high temperature warning limit .
out_sp_04 xxx.x
Set low temperature warning limit .
out_hil_00 xxx Set the desired maximum cooling power (0 % to 100 %).
This adjustment is required only for proportionally controlled
refrigerated circulators.
out_hil_01 xxx Set the desired maximum heating power (10 % to 100 %).
out_par_04 xxx Band limiting during external control.
Setting the maximum difference between the temperatures
in the internal bath and external system.
out_par_05 xxx Ratio for max. cooling power versus max. heating power
(0...0.99).
out_par_06 xxx Xp control parameter of the internal controller.
out_par_07 xxx Tn control parameter of the internal controller.
out_par_08 xxx Tv control parameter of the internal controller.
out_par_09 xxx Xp control parameter of the cascade controller.
out_par_10 xxx Proportional portion of the cascade controller.
out_par_11 xxx Tn control parameter of the cascade controller.
out_par_12 xxx Tv control parameter of the cascade controller.