INFICON PSG55x ATM to Medium Vacuum Gauge (EtherCAT) - Manual (Page 55)

tira85e1 (2013-06) PxG55x.cp
55
Response
Byte 0
See Subindex 0x02
Byte 1 Unused
Byte 2 0: Zeroing successful
1: Zeroing failed; out-of-range
2: Zeroing failed; cumulative out-of-range
3: Zeroing failed: measurement invalid
255: No previous Zero Adjust command issued
Execution of this command will start a Full Scale Adjust operation.
Index SI DataType NV Access PM Name
FB41 0x01 V_STRING RW Command
0x02 BYTE RO Status
0x03 V_STRING RO Response
Command
Byte 0
0: Full Scale Adjust
Byte 1 Index of the Sub Sensor Instance (1-8)
Byte 2…5 Full Scale value (Data format: REAL, always 0)
Status (supported values)
0
1
2
3
255
Last command completed, no errors, no reply available
Last command completed, no errors, reply available
Last command completed, errors present, no reply
available
Last command completed, errors present, reply available
Command is executing
Response
Byte 0
See Subindex 0x02
Byte 1 Unused
Byte 2 0: Full Scale Adjust successful
1: Full Scale Adjust failed: out-of-range
255: No previous Full Scale Adjust command issued
Execution of this command causes the device to emulate a complete power cycle.
This includes an ESC reset. An SDP may limit some behavior of the power cycle
emulation, but shall not exclude the EtherCAT interface.
As consequence of an ESC reset all following devices are disconnected
from the network.
There are two versions of this command:
• Standard reset (as described above)
• Factory reset (as described above, but additionally, all parameters are restored
to as-shipped defaults).
Index SI DataType NV Access PM Name
FBF0 0x01 V_STRING RW Command
0x02 BYTE RO Status
0x03 V_STRING RO Response
Subindex 0x03
4.18.2 Full Scale Adjust
Subindex 0x01
Subindex 0x02
Subindex 0x03
4.18.3 Device Reset
Command